产品说明：超白净味水漆采用先进净味技术研发的健康水性乳胶漆产品，能为墙面提供全方位优异的保护和装饰性能。特别在耐洗刷易清洗，抗粉化性能和漆膜遮盖力等多方面有优异的表现。而且漆膜具有极其优异的柔韧性，能有效覆盖墙面细微裂纹。

产品特点：

◎ 超强的干膜遮盖力  

◎ 涂刷面积大，覆盖面广

◎ 绿色环保  

◎ 施工方便

适用范围：适用于住宅、酒店、办公楼、学校等大型建筑物的内墙涂装。

施工说明：

◎ 施工条件:请不要在潮湿或寒冷的天气(气温低于5℃,相对湿度≤85%)情况下施工，否则不能达到预期的涂装效果。

◎ 涂装体系:刷涂、轮涂、喷涂，无气喷涂效果更佳。

◎ 保养:贮存于阴凉干燥，温度在5°C-35℃的环境中。

基面处理：

◎ 新建墙面:清除表面灰尘、油腻和松散泥灰，如果有空隙请及时修补,确保墙面干燥，整洁平整。确保预涂基材表面湿度小于10%,PH值小于10。

◎ 重涂墙面:铲除旧墙面不牢固的漆膜,清除表面灰尘粉化物和杂质批平打磨,清洗并彻底干燥。预涂基材表面必须牢固、干燥、清洁、平整和无松脱物质。

注意事项：

◎ 请务必于使用前仔细阅读包装文字中的施工说明,以获得可靠和满意的涂装效果。

◎ 如是过敏性皮肤，请在使用中始终佩戴防护用具。

◎ 如不慎沾染眼部，请立即用大量清水冲洗,并寻求医疗救助。

◎ 请不要让儿童或宠物进入施工区域,并将产品放置于接触不到的地方。

◎ 当涂料打翻外漏时,用沙或泥土覆盖后收集并合理处置，切勿把涂料倒入下水道或排水管。

Product Introduction:

Super white clean flavor water paint is a healthy water-based emulsion paint product developed by advanced clean flavor technology, which can provide all-round excellent protection and decoration performance for the wall. In particular, it has excellent performance in washing resistance, easy cleaning, anti pulverization performance and paint film covering power. Moreover, the paint film has extremely excellent flexibility and can effectively cover the fine cracks on the wall.

Product Features:

◎ Super dry film coverage             

◎ Large painting area and wide coverage

◎ Green environmental protection

◎ Convenient construction

Range of Application:

It is suitable for interior wall coating of residential, hotel, office building, school and other large buildings.

Construction Instructions：

◎ Construction conditions: please do not work in wet or cold weather (temperature lower than 5 ℃, relative humidity ≤ 85%), otherwise the expected coating effect cannot be achieved.

◎ Coating system: brush coating, wheel coating, spraying, airless spraying has better effect.

Maintenance: store in a cool and dry environment with a temperature of 5℃-35℃.

Base Surface Treatment：

◎ New wall: remove the dust, grease and loose plaster on the surface. If there is any gap, please repair it in time to ensure that the wall is dry, clean and flat. Ensure that the surface humidity of the precoated substrate is less than 10% and the pH value is less than 10.

◎ Repainting the wall: remove the unstable paint film on the old wall, remove the dust, powder and impurities on the surface, level, polish, clean and dry thoroughly. The surface of the pre coated substrate must be firm, flat, clean, fully dry and free of floating dust and porosity.

Matters Needing Attention：

◎ Please carefully read the construction instructions in the packaging text before use to obtain reliable and satisfactory coating effect.

◎ In case of allergic skin, always wear protective equipment during use.

◎ In case of accidental eye contact, please wash immediately with plenty of water and seek medical assistance.

◎ Please do not let children or pets enter the construction area and place the product out of reach.

◎ When the paint spills out, cover it with sand or soil, collect it and dispose it reasonably. Do not pour the paint into the sewer or drainage pipe.