19世纪末，德国物理学家菲利浦·莱昂纳德(Philip.lionad）博士第一次在学术上阐述了负氧离子对人体的功效。他提出存在于自然环境中的负氧离子有益于人类健康，并指出负氧离子含量最多的地方是在山谷瀑布森林周围。

世界卫生组织规定，清新空气的负氧离子标准浓度为每立方厘米空气中应不低于1000-1500个。

产品储存：存放于阴凉干燥处，产品无毒不燃。

基层要求：墙体基层应坚实、干净、平整、干燥程度适中(含水量≤15% )。

施工方式：批刮、打磨。

施工环境：温度≥5℃，湿度≤85%，通风良好。

加水比例：本品加水比例约为1:0.4(料:水重量比)，搅拌均匀后静止20分钟使用最佳。

批刮厚度：单遍批刮厚度建议为0.6-1.1mm，须两遍完工;第一遍初干后(一般6-24小时）批刮第二遍，在第二遍完全干燥后进行打磨平整。

涂布面积：理论涂布面积:8-11m²/18kg/两遍(因施工表面的粗糙平整程度不同，产品耗量也有所不同)。

注意事项：不准与其它粉料混合使用，施工用料需一次批刮完毕，不可间隔使用。

施工要求：

基层处理：基层坚实无浮灰和污物，墙体表面含水率应低于5%。

搅拌本品：直接加水搅拌，稠度以最佳施工为宜，粉:水为1:0.41；稠度根据一次性找平厚度适当微量调整，以最佳施工为宜。

使用本品：将调好的本品刮至石膏板缝里，凝固后再刮一遍，通常刮两遍。搅拌后的产品要一次性用完，初凝后不允许再加水搅拌使用。

本品只能用清水调和使用，不能同其他任何产品混合使用。

Product Storage：Store in a cool, dry place, non-toxic and non-flammable.

Grass-roots requirements：The base of the wall should be firm, clean, level off and of moderate dryness (moisture content ≤15%)

Construction method：Scraping and sanding.

Construction Environment：Temperature ≥5 °C, humidity ≤85% , good ventilation

Water ratio：The product added water ratio is about 1:0.4(material: Water Weight Ratio) , after mixing evenly static 20 minutes to use the best.

Batch thickness：The thickness of single-pass scraping is suggested to be 0.6-1.1 mm, to be finished twice; the first time after drying (usually 6-24 hours) the second time, after the second time completely dry to smooth.

Coating area：Theoretical Coating Area: 8-11m2/18kg/twice (product consumption varies according to the roughness of the construction surface)

Points to note：Do not mix with other powder materials, construction materials must be a batch of scraping finished, not interval use.

Grassroots   treatmengt : a solid foundation without floating ash and dirt, the wall surface moisture content should be less than 5% .

Stirring this product: direct   water mixing, consistency to the best construction is appropriate, powder than water is about 1:0.41; The thicknoss is adjusted according to the appropriate trace thicknoss of the one-time leveling. and the best construction is appropnate

The use of this product: this will be good to scratch this gypsum board scratch, solidification and then scraping it again, usually scraping twice. After mixing the product to be run out of one-time,after the initial setting is not allowed to add water and stirring to use.This product can only be reconciled with water, can not be mixed with any other product.